USA Made Conrader In Tank Check Valve for Air Compressors, 1/2" Compression Inlet X 3/4" Male NPT Outlet, Double Tapped 1/8" Unloader Ports

Conrader Ctl-series Check Valves Are Used In Compressed Gas And Pneumatic Systems. Check Valves Have Two Ports And Restrict The Flow Of Fluids And Other Loose Materials Through A Pipe Or Passageway To One Direction. These Valves Open To Allow Flow In One Direction And Close When The Flow Stops Or Reverses. The Ct-series And Ctl-series Have A Male Outlet Connection For Use In Tanks And Receivers. This Conrader In-tank Check Valve Is A Poppet-type Valve, And May Be Disassembled For Servicing And Repair. The Valve Body Is Made Of Brass For Corrosion Resistance, Ductility At High Temperatures, And Low Magnetic Permeability. Brass Can Be Connected To Copper, Brass, Plastic, Aluminum, And Welded Steel. This Valve Has A Reinforced Polytetrafluoroethylene (Ptfe) Poppet With Eight Discharge Holes For Quiet Operation, And Stainless Steel Spring. The Maximum Pressure Rating Is 500 Pounds Per Square Inch (Psi), And The Maximum Working Temperature Is 450 Degrees Fahrenheit. Check Valves Are Rated By Their Cracking Pressure (The Minimum Upstream Pressure Required For The Valve To Operate), And They Are Used In Various Water, Gas, Air, And Steam Lines. We Include Compression Nut And Ferrule With Each Variation. Materials Of Construction: Body: Brass Valve Housing: Brass Seal: Reinforced Ptfe Spring: 302 Stainless Steel

• 1/2" Compression Tube Top Inlet X 3/4" Male NPT Bottom Outlet To Receiver Tank, Made In The USA
• This Double Tapped Check Valve Comes Equipped With Two 1/8" Female NPT Unloader Ports Located Side Hex. The Additional Port Is Commonly Used With Other Components Depending On the Systems Design
• Compressor Pump Discharge Inlet Connection: 1/2" Compression Tube Inlet Designed for 1/2" OD Copper or Aluminum Tubing
• Outlet Connection to Receiver Tank: 3/4" Male NPT, 500 PSI Max, 30 CFM Flow Rate, -65° to 450°F, Reinforced PTFE Seal
• Compression Nut and Ferrule Included