NGW-1PC CANBed - CAN-Bus RP2040 development board for Arduino

CANBed CAN Bus development board equipped powerful RP2040 has high-performance CAN controller and receiver operating at CAN 2.0 up to 133Mhz. It has flexible CAN interface which can be used as 4-PIN Terminal or D89 connector as OBD-II mode through a programmable Micro USB. CANBed RP2040 is a CAN Bus development board equipped with an RP2040 chip with a high-performance MCP2515 CAN controller and MCP2551 CAN receiver operating at CAN2.0 protocols in 133MHz. The board contains a flexible CAN interface where it can be used 4-PIN Terminal or D89 connector. D89 connector can be directly used as OBD-II mode by default and the hardware can be configured as CAN Open mode as well. Additionally, it has a rich interface in which there is a Micro USB connector that can be programmed instead of supplying power. It also has I2C, UART, SPI, 3 analog input interfaces, and 8 digital IO with 2MB of Flash and 264KB of RAM which make it suitable for most embedded applications. If you want to use this board to develop OBD-related applications, click to get a DB9 to OBD-II cable. We use a flexible way for the CAN interface. You can use 4PIN Terminal or DB9 connector. DB9 connector uses OBD-II mode by default. You can also configure CAN Open mode on the hardware. The voltage input range of the CAN interface is 9-28V, which can provide a stable 3.3V/1A output.

• Implements CAN V2.0B at up to 1 Mb/s
• Powerful RP2040 processor
• Industrial standard 9 pin sub-D connector or 4PIN Terminal. OBD-II and CAN standard pinout selectable at the sub-D connector
• SPI Interface Standard (11 bit) and extended (29 bit) data and remote frames Power input from 9-28V