MECCANIXITY 50Pcs Heat Shrink End Cap 25mm ID x 40mm l 1.3:1 Ratio Heat Shrink Tubing Caps Lined Sealed Waterproof Adhesive for Electrical Wire Cable, Black

What is this?The spiral melt adhesive in the inner layer of the heat-shrinkable cable cap has good flexibility after shrinkage. It can provide moisture-proof sealing protection for outdoor and underground PVC, or other cables, power communications, and lighting line terminals.What will I get?The Heat Shrink End Caps provide here, is in the size of:Size: 25 x 40mm/0.98 x 1.3:17 inch (ID*L)Outer Diameter: 27mm/1.06 inchShrink Ratio: 1.3:1Shrink Temperature: 120℃-250℃Material: POIn the package of: 50Pcs x Heat Shrink End CapsAre there any advantages of the product?Using temperature-resistant and flame-retardant materials, it is secure and reliable, has strong chemical corrosion resistance, and has good heat resistance and insulation.1.3:1 shrinkage, the hot-melt adhesive inner layer provides airtight protection and easy and convenient installation on cable terminations. Provide sealing, waterproofing, insulation, and protection effects for electricity and control cable terminals.How to use it?1. Put a heat-shrinkable cable gland over the outer protective layer at the end of the cable.2. Heat the heat-shrinkable cable gland so that it shrinks around the end of the cable.3. The heating temperature needs to be controlled well. Stop heating when the shrinkage is in place and the glue over-flows.What should I notice?Please allow slight errors due to manual measurement.

• The spiral melt adhesive in the inner layer of the heat-shrinkable cable cap has good flexibility after shrinkage. It can provide moisture-proof sealing protection for outdoor and underground PVC, or other cables, power communications, and lighting line terminals. Note: For inner diameters of 30mm and below, a heat gun is recommended. For diameters above 30mm, a blowtorch is recommended.
• Size: 25 x 40mm/0.98 x 1.57 inch (ID*L); Outer Diameter: 27mm/1.06 inch; Shrink Ratio: 1.3:1; Shrink Temperature: 120℃-250℃; Material: PO; In the package of: 50Pcs x Heat Shrink End Caps
• Using temperature-resistant and flame-retardant materials, it is secure and reliable, has strong chemical corrosion resistance, and has good heat resistance and insulation. 1.3:1 shrinkage, the hot-melt adhesive inner layer provides airtight protection and easy and convenient installation on cable terminations. Provide sealing, waterproofing, insulation, and protection effects for electricity and control cable terminals.
• 1. Put a heat-shrinkable cable gland over the outer protective layer at the end of the cable. 2. Heat the heat-shrinkable cable gland so that it shrinks around the end of the cable. 3. The heating temperature needs to be controlled well. Stop heating when the shrinkage is in place and the glue over-flows.
• This product has different uses from heat shrink tubing. Since it is thicker than ordinary heat shrink tubing, it takes longer to heat up. It is mainly used for end protection of cables and screws.Instructions for use: Use professional tools (such as a heat gun) to heat evenly according to the specified working temperature (120 degrees). Do not concentrate the heating on a certain point. The recommended heating time for different diameters is as shown in the picture.